An Introduction to Steam Turbine Design

Portada
J. Paul Guyer, P.E., R.A.
Guyer Partners, 2017 M12 16 - 49 páginas
Introductory technical guidance for mechanical engineers and other professional engineers and construction managers interested in steam turbines. Here is what is discussed:
1. TYPICAL PLANTS AND CYCLES
2. COGENERATION IN STEAM POWER PLANTS
3. TURBINE TYPES
4. TURBINE GENERATOR SIZES
5. TURBINE THROTTLE PRESSURE AND TEMPERATURE
6. TURBINE EXHAUST PRESSURE
7. LUBRICATING OIL SYSTEMS
8. GENERATOR TYPES
9. GENERATOR COOLING
10. TURBINE GENERATOR CONTROL
11. TURNING GEAR
12. TURBINE GENERATOR FOUNDATIONS
13. AUXILIARY EQUIPMENT
14. INSTALLATION
15. CLEANUP, STARTUP, AND TESTING
16. OPERATION.
 

Páginas seleccionadas

Términos y frases comunes

15 psig actual steam rate Air SCSF automatic extraction opening Automatic extraction turbines Back pressure turbine boiler calculated centrifuge condenser pressure determined by dividing district heating electrical power engine efficiency exhaust or extraction exhaust steam pressure extraction steam Gas Turbine gross heat rate heat added heat balance Hg Abs high pressure extraction Hydrogen TCDF kilowatt lb/kWh low pressure turbine lubricating oil system mixed pressure MULTISTAGE TURBINES NONCONDENSING oil coolers operating heat rates Particle filters percent chromium PLANT HEAT RATE pressure and temperature pressure steam Rankine cycle rate is determined rate is expressed shown in Figure shown in Table single stage turbines Single valve steam distribution pressure steam power plant steam turbine storage compartment storage tank TCSF theoretical steam rate tube material turbine exhaust pressure turbine generator manufacturers turbine generator units TURBINE HEAT RATE turbine oil reservoir turbine throttle pressure Turbine type type of turbine utilization

Acerca del autor (2017)

 Paul Guyer is a registered civil engineer, mechanical engineer, fire protection engineer, and architect with over 35 years of experience in the design of buildings and related infrastructure.  For an additional 9 years he was a senior advisor to the California Legislature on infrastructure and capital outlay issues. He is a graduate of Stanford University and has held numerous national, state and local positions with the American Society of Civil Engineers, Architectural Engineering Institute and National Society of Professional Engineers.  He is a Fellow of ASCE, AEI and CABE (U.K.).

Información bibliográfica

TítuloAn Introduction to Steam Turbine Design
EditorJ. Paul Guyer, P.E., R.A.
EditorGuyer Partners, 2017
Largo49 páginas
  
Exportar citaBiBTeX EndNote RefMan